Losi MTXL 1/5 Scale...Chassis Skin Protector...3D Textured Carbon Fiber.. New

Description

This is for 1
Chassis Skin Protector Kit
From: Race Ready RC Parts
Kit includes:
1 Sheet of 3D Textured Carbon Fiber
8" x 30"
This 3D textured Carbon Fiber is a super 5.9 mil thick.
It gives your Chassis or Parts the Look and Feel of
Real Carbon Fiber.
Keep your Chassis looking new
or make your Chassis look new again.
We only use the highest quality vinyl
Not only will your RC look good,
it will keep it protected.
Instructions
For Installing
... Chassis Skin Protector...
1.
Remove Front & Rear Skid Plates
2.
Clean your Chassis real good... then wipe with Alcohol & let dry...
3.
Cut the vinyl to approximate size...
4.
Peel the back off of the Vinyl and apply... lining up with one of the edges and pushing out any air bubbles from one side to the other…
5.
Reinstall Front & Rear Skid Plates
6.
Once applied use a new sharp
exacto razor knife
to trim around the edges...change the blade often for an easy smooth installation... and cut out the gear hole.
7.
The vinyl doesn't fully adhere immediately so even if you make a mistake you can simply peel back and re-apply.